How To Install Linksys Velop Quickly?

The Linksys Velop device helps to boost the WiFi signal range. The installation process of the Linksys Velop device is so simple. To know more about the Linksys Velop study this page’s entire information.

Access To Linksys Web Management Page

To access the Linksys web management page of Linksys Velop, consider the below information.

First, place the Linksys Velop device power plug into the working power socket. After that, take the computer or laptop and link with the Linksys Velop default WiFi network. Further, in the Chrome address bar type official IP address. Later, fill in the password and username information in the required fields. At last, tap on the login button to enter the Linksys web management page.

Steps To Install Linksys Velop

Initially, install the Linksys application from any app store on your cell phone. Now, press the power button of the modem to turn it off. Next, unplug and take out the old router from the modem. Later, connect the ethernet wire from the modem to the Linksys Velop ethernet port. Further, verify that on your cell phone, Bluetooth must be on. Thereafter, power on the Linksys Velop by pushing the power button. Thus, open the downloaded Linksys application on your cell phone and consider all the display instructions to complete the Linksys Velop setup process.

Troubleshoot Linksys Velop Troubles:-

There are several ways or tips to fix the Linksys Velop Trouble

• Upgrade Linksys Velop Firmware:- To improve the software of Linksys Velop, connect the computer first with the Linksys Velop default network. After that, open the browser and type Velop’s official IP address in the URL bar. Further, fill in the default information shown on the Linksys web management page. At the end, tap on the software installation option and install the latest software file.
• Power Cycle Velop:- At the bottom of the Linksys, the power button is located. Push that power button to power off the device. After that, from the electrical socket take out the Velop power plug. Later, wait and put the Velop power plug back in the socket. Finally, press the bottom power button of Linksys Velop again to turn it on again.
• Switch Velop Position:- By switching the position of Linksys Velop or placing Velop at house central location you can also fix the Velop error. But make sure that the Linksys Velop device doesn’t settle near the electronic appliances.
• Execute Hard Reset Process:- Look for the reset on Linksys Velop. As we tell you, the reset button is located at the bottom of the unit. Push the reset button by inserting a pin in it for 10 to 15 seconds. Now, all the Linksys Velop LEDs will turned off. All Linksys Velop off LEDs indicate that the unit is completely reset now.
• Important Note:- Make sure after resetting Linksys Velop you will required to do the login and configuration process again.

After reading all the directions on this page, we hope you will be able to do the Linksys Velop setup by yourself without getting any technical help. If you want more updates or information on the Linksys Velop unit then stay always near this post.