Simple Setup Procedure Of Linksys Velop

Confused about how to set up the Linksys Velop? Don’t worry, you can take a detailed and simple guide from here. This guide will tell you like how you can just configure the Velop and get the best performance of the device.

Setup Without The App

Many times it feels tough to set up the Linksys Velop, but there is nothing to worry about as you can also set up the device without any app. Here are some of the simpler ways to do it using a web browser. Follow these steps.

Take A Look Over Before You Turn On

• First of all, keep a laptop or computer handy.
• Factory reset the node using the reset button.
• Press the button tightly till the light on the extender light starts flashing solid red.
• Use an ethernet wire to attach the modem but make sure the node is also ON.

From Here Start The Steps

• To begin the Linksys Velop Setup, first, just attach your velop device with a power socket.
• Thereafter, just attach the parent node with your modem.
• After that, ensure you are enabled with an Ethernet wire with you.
• Make sure that both devices are turned on.
• Anyhow in case you are not up with any internet connectivity, just connect your Velop nodes simultaneously and make sure the wires are also attached.
• If so, try rebooting the modem by unplugging it and then plugging in the power cord again after 30 seconds.
• There you need to wait for the lights to blink again after a short while.

Before checking If It’s Working Properly

• When you are about to start the process make sure, to place all your Linksys nodes at different corners of your house.
• Active connection between every node is necessary and there should be an active terminal device, for example, a laptop or a computer so that they can work efficiently.
• The LEDs on every node will turn up-sold blue if the connection between the devices would be great.
• Make your computer ready and launch a web browser to connect to the WiFi networks.
• Now it’s your turn to put the IP address in the URL space of your browser meanwhile press the enter button.
• The IP address is always finable on the router’s back.
• Using the default password which is (admin) Log into the Mesh WiFi system.
• Under the connectivity click on CA setup.
• Tap on “Setup a new device”.

Let’s Take a Look Over Secondary Node Setup

• First, just locate the Linksys app on your device and then tap on the Launch button from the bottom.
• Followingly Select the Allow button.
• Select the agree button when you are like ready to continue, select the agree button.
• Then, mark the Velop button shown on the display.
• Thereafter select the Modem and router separately.
• Then, just select the velop nodes after plugging the device.
• Make sure the area you are choosing to plug the device should be open.

Thus, you can complete the Linksys velop setup and other nodes using this simple setup guide. However, if you are seeking more guidance with your device, get in touch with our expert team.