How To Setup Linksys RE7000 Using A Web Interface?

Brought new linksys RE7000 device to extend your home network. Don’t know how to move ahead. No worries, this web page is created to offer a detailed guide about linksys re7000 setup. To commerce the process you don’t need technical expertise, just a little knowledge is enough. Gather information from further sections of this page and extend your existing network to every corner of your home. Once you configure re7000 accurately, you no longer face dead zones or weak signal zones. Without discussing anything further lets begin the setup.

Linksys RE7000 Setup Steps

You can proceed with the Linksys RE7000 configuration by using web, app or WPS method. All the setup methods are simple. You can move further with any of them. But here we will elaborate about web based configuration in detail. With the web based setup method you can make changes in several settings of the device including change password, access control, update firmware and much more.

Unbox Your Linksys RE7000

First step of the linksys re7000 setup process is device unboxing. With the linksys RE7000 extender device you will get a power adapter, ethernet cable and user manual. Take the extender device out of the packing very carefully.

Place The RE7000 Extender

Secondly, you need to look for a placement to keep the extender device. For the initial setup you need to place the device proxy to your home networking device. Proximity will help while configuring. Once the linksys re7000 setup completes you can move the device to another place.

Power Your Linksys Extender

Powering the linksys extender device will take a few minutes. Connect the power adapter that comes with the extender device to the power port. Plug-in the power adapter into the power outlet to turn on the power of your linksys extender. Turn on the power button and watch out for the device’s power LED.

Connection Between Client Device & Extender Network

Once the device is turned on you need to establish connection between the range extender device and the client device. Client device stands for a device by which you are going to access the web interface. You can establish connection by using cable or via wireless method. Cable connection requires ethernet cable and wireless method requires access to WiFi setting of the device.

Setup Linksys RE7000

You may proceed with the linksys re7000 setup by following:

• Use a web browser to proceed with the process in the same device you connected with the re7000 network.
• Access “extender.linksys.com” or “192.168.1.1” web address.
• When the page is open choose “Set up range extender” option and then select your device model.
• Afterwards follow the on screen instructions as displayed to complete the configuration.
• Also provide the SSID & Password of your existing network to connect.
• At last choose the finish option and test the network.

Relocate The Extender

As the linksys re7000 setup completes, you need to relocate the extender device. The new location of the device must be an ideal one. Device should be within the range of home host networking device. Also consider to keep it not too far from the area where you were facing issues with signals.