How To Connect A Linksys RE7000?


Live Chat

Live Chat with our experts & get real-time answers to all your queries.

Any Query?

Call us to discuss your Linksys issues with our experts and get the solution.

Linksys RE7000 Setup | How to Connect Linksys RE7000 Range Extender

The range extended device works to bridge the gap between the placement of the router and the area where router signals are hard to reach. Among all the range extender devices offered by Linksys, RE7000 is the most popular model. RE7000 is a compact wall plug device with the latest technology. You can use the device to get rid of WiFi dead zones or slow signal problems. Confused about how to connect a linksys re7000? Not an issue, read the section together with several important details about the setup and installation of the device. 

RE7000 Setup Requirements

Before diving into how to connect a Linksys RE7000 it is important to know what things are required to do it. Check out the list of requirements to get your device connected with the existing network. 

  • Linksys RE7000 Range Extender 
  • Power outlet 
  • Client device
  • Ethernet cable 
  • Host router with active internet connection
  • Router the SSID and password 
  • Extenders default SSID and password

RE7000 Installation

You need to install the range Extender device before initiating the setup. So check out the installation process here and then proceed with how to connect a Linksys RE7000.

  • Near your router device placement look for a wall plug to install the re7000 range Extender.
  • Connect the device with the plug and turn on the power supply. 
  • When the LED on the device front starts blinking green that means the power supply is on. 
  • Let the device boot up and then configure using any of the below specified methods.

Linksys RE7000 WPS Setup

Check out further how to connect a Linksys RE7000 using the WPS button. Make sure your devices properly installed before preceding with these steps: 

  • First locate the WPS button on the router device and then on the extender device. 
  • Push the button in the same order first on the router device and then on the extender device. 
  • Make sure you push the buttons within 2 minutes as taking more than 2 minutes may fail the process. 
  • After pushing the button you have to monitor the extenders LED to check if the process is done or not. 
  • If the LED turns green solid colours then the process is successful on the contrary if it shows red colour then the process fails.

Linksys RE7000 Web Setup

How to connect a Linksys RE7000 using a web based method is specified underneath. You just need to do is follow the process as mentioned: 

  • When your extender installation is done, you have to choose a client device to proceed with the configuration. 
  • Connect your chosen device to the range Extender network either using ethernet cable or wireless method. 
  • After establishing the connection, launch the web browser to reach out to the setup page. 
  • Use the default IP or extender.linksys.com web address and then mention the admin default details to enter the portal.
  • First connect the extender with the router using the routers SSID and password.
  • Now do the variations as per your requirement.
  • After doing all the changes save it and let the device apply the changes. 
  • Relocate your range extender to boost the network performance if needed.

Connect Us

Even after reading the above steps you are confused or find it difficult to proceed with the configuration of your range extender. Not an issue, our technical staff is here to guide you. Our technical team is expert in briefing how to connect a Linksys RE7000. What you have to do is just give us a call. Don’t look over the time you can call us anytime during the day or night whenever you need help. Call Now!