Having Linksys Velop issues? Here is How You Can Fix Them!

Linksys Velops are great devices that make it simple to grow your WiFi network. It can be annoying, though, if the WiFi Velop isn’t working properly. Thankfully, a few easy steps can fix major problems with the Linksys WiFi Velop setup or slow WiFi.

Turn Off All of Your Electronics

• Switch off every device that can connect to the internet via wifi, such as the router, Velop, and other gadgets.
• Give it 30 seconds before moving on.
• Prior to turning on your router, turn on the Velop.

Verify Internet Connectivity

First, confirm that you can access the internet and use your computer or mobile device. This step is crucial because if your internet connection isn’t functioning properly, it will be difficult to fix any WiFi Velop issues, including Linksys Velop setup. It might be necessary for you to unplug and then re-plug your modem and router to restart them.

Check Your Router and Modem

Next, check that all of the cables connecting the modem to the router—not just the ones coming from one end—are in good operating condition. Verify that they are firmly inserted into their sockets and that, if necessary, there are no loose connections or bent pins. swap out each cable for a new one that is within the Velop’s reach and from a different location. This will help identify whether or not a certain cable is the cause of the issue. Inspect these cables for any loose screws holding them in place. If so, tighten them until they are firmly in place against the ports and sockets on each device. You might then need to configure your Linksys router.

Analyse Firmware Versions

Verify the firmware versions loaded on both devices by going to Network Settings > About this Computer > Hardware Version + Management Information > Software Version > Advanced Settings > System Information (on DD-WRT routers).

Next, compare this data with similar devices running different firmware versions in the event of recent updates. They might be the cause of the strange behavior.

Restart Your Modem and Router and Check Your Cable Connections

• Turn all of your devices back on.
• To reset your WiFi Velop, unplug it for 30 seconds, then connect it back in.
• You may reset your WiFi router by unplugging it for thirty seconds and then plugging it back in.
• Finish setting up the Linksys router if the issue continues.

Verify Your Password for WiFi

Verify the password for your WiFi network. The first thing to do when your Wi-Fi Velop stops working is to make sure you remember the password—or even whether it is right!

Verify the Velop’s Wi-Fi name and channel settings, as well as those of the router and any connected computers or devices. Changing these settings might fix the problem! It’s possible that you’ve set up a different name or channel than what functions well with other devices in your home network!

Put Velop Inside the Range of Your Router

Verify that the Velop is within the WiFi range of your router. The most common reason for Linksys WiFi Velop setup issues is this. You need to move your Velop closer to the router if it’s out of range. Verify that your device is within range of the WPS button on your router (Velop).

Update the Firmware

If your wifi Velop hasn’t been operating for a while, the firmware might be the problem. Your device’s firmware, which is the operating system, may include bugs that prevent the wifi Velop from connecting to your router. If there are any available firmware updates, you can update them by visiting the manufacturer’s website. Speak with the manufacturer if you need help with how to update the firmware on your device.